HMT-2015 HuiMinTong Desoldering Wick – Clean Up Solder Mistakes in Seconds
Solder bridges, flooded pads, and joints with too much solder are part of every repair bench's daily work. HMT-2015 desoldering wick makes cleanup simple: press the braided copper against the molten solder and it soaks the excess up like a sponge, leaving pads clean and ready for rework. Whether you are clearing a shorted pin on a phone board or desoldering a through-hole component, this wick helps you undo soldering mistakes without damaging the board.
Why You'll Reach for It on Every Rework
Fast, thorough solder pickup – fine copper braid draws molten solder away from pads, pins, and through-holes in one pass
Flux-enhanced braid – pre-fluxed for quick, even heating and reliable solder flow into the wick
Clean, shiny results – leaves pads free of bridges, blobs, and excess solder, ready for the next component
Gentle on boards – quick heat transfer means less time on the pad, protecting traces, pads, and temperature-sensitive components
Handy spool – the wick feeds from a spool and stays flat and flexible for easy positioning on tight SMD work
Pack Sizes That Fit Your Bench
1 roll – a convenient starter or top-up roll for occasional rework
5 rolls – good value for an active repair bench
10 rolls – best value for workshops and high-volume technicians
How to Use
Lay the wick over the solder you want to remove.
Press your soldering iron tip onto the wick above the joint.
Let the heat draw the molten solder up into the braid.
Lift the iron and wick together, then trim off the used section of braid.
Clean the pad and inspect before re-soldering.
Specifications
Model: HMT-2015 (X300 series)
Type: Fluxed copper desoldering wick
Pack options: 1 roll, 5 rolls, 10 rolls
Applications: removing solder bridges, clearing through-holes and SMD pads, desoldering components, and general PCB rework
Who It's For
An essential consumable for phone and laptop repair technicians, PCB rework shops, and electronics hobbyists. Stock a few rolls at every station – desoldering wick is the tool you never want to run out of mid-repair.
Tip: keep the braid clean and trim off used sections often – fresh braid pulls solder far faster than a burnt, saturated end.
